|
| |

71102 MECHANICAL KANGAROO
Tamiya presents the robot replica of the beloved
kangaroo from Australia. This amazing kangaroo-robot jumps by moving its rear
legs simultaneously to go forward. When walking slowly, it also uses its front
legs (just like they do down under) and when running quickly, it uses its tail
for balance. Legs and body on which the gearbox is mounted employ
transparent-coloured parts, giving the kangaroo a funky look. Reverse switch is
also transparent, giving you a peek at the kangaroo's internal mechanisms.
-
Assembly is very simple with use of screws
and snap-lock parts. Cable ends are rubber capped with cut areas pre-marked
for easy wiring.
-
A gearbox transforms the motor movement to
make the kangaroo's rear legs move. You can choose between two different
gears for gearbox assembly. When using the low speed gearbox, rods are
attached to the lower holes of front legs and kangaroo walks standing on its
tail.
-
When using the low speed gearbox, rods are
attached to the upper holes of front legs. Changing rod position using
different holes in the crank plate gives you 4 different speed possibilities
within slow speed mode. When walking slowly, it impressively imitates a real
kangaroo's movement.
-
Changing the position of the tail allows the
kangaroo to keep balance during high-speed running and enables it to change
direction. Putting the tail straight will make the kangaroo go straight but
setting it to the right/left will make the kangaroo turn to the right/left.
-
Total length: 180mm,
-
Total
weight: 95g (w/ out batteries)
-
Body
material: ABS resin
-
2
gears included, one for high speed and one for low speed.
-
Motor
and reverse switch also included.
-
Screwdriver
for assembly is included.
-
Requires
one R6/AA/UM3 battery (sold separately).
-
Continuous
running time with Alkaline battery: 3hrs. at low speed/1hr. at high speed.
TAMIYA
ROBOCRAFT SERIES |